CHKNTFS
(chkntfs)
在启动时显示或修改磁盘检查。
CHKNTFS volume [...]
CHKNTFS /D
CHKNTFS /T[:time]\r\nCHKNTFS /X volume [...]
CHKNTFS /C volume [...]
volume: 指定驱动器(后面跟一个冒号)、装入点或卷名。
/D 将计算机恢复成默认状态， 启动时检查所有驱动器，并对有问题的驱动器执行 chkdsk 命令。
/T:time 将 AUTOCHK 初始递减计数时间改成指定的时间量，单位为秒数。如果没有指定时间，则显示当前设置。
/X 排除启动时不作检查的驱动器。上次执行此命令排除的驱动器此时无效。
/C 安排启动时检查驱动器，如果驱动器有问题，运行 chkdsk。
如果没有指定命令行开关，CHKNTFS 会显示每一驱动器有问题的位的状态。
Displays or modifies the checking of disk at boot time.
CHKNTFS volume [...]
CHKNTFS /D
CHKNTFS /T[:time]
CHKNTFS /X volume [...]
CHKNTFS /C volume [...]
volume Specifies the drive letter (followed by a colon), mount point, or volume name.
/D Restores the machine to the default behavior; all drives are checked at boot time and chkdsk is run on those that are dirty.
/T:time Changes the AUTOCHK initiation countdown time to the specified amount of time in seconds. If time is not specified, displays the current setting.
/X Excludes a drive from the default boot-time check. Excluded drives are not accumulated between command invocations.
/C Schedules a drive to be checked at boot time; chkdsk will run if the drive is dirty.
If no switches are specified, CHKNTFS will display if the specified drive is dirty or scheduled to be checked on next reboot.